Maytronics Power Supply Not Turning On

As a result that light shouldn t turn on again until the filters begin to fill up or are full.

Maytronics power supply not turning on.

Close the unit casing turn it on and let it run. Wait 30 seconds then turn it back on. See the relevant section below for more details on each program. We had been using it then i shut it off to clean out filter and it will not come back on.

Unplug the power supply. You ll know the app is connected if the power supply buttons are overridden in disable mode. Open the impeller cover and check that nothing is trapped in the impeller. If the psu turns on and the lights stay on the problem is not with the psu.

We had been using it then i shut it off to clean out filter and it will not come back on. Unplug the blue cable from the power supply unit psu and turn it on. Ensure the power outlet is functioning properly and that it has not tripped the breaker in the fuse box. Check power to the socket and reconnect pool cleaner.

Open the impeller cover and check that nothing is trapped in the impeller. To check your maytronics diagnostic power supply use a multimeter set to 200vdc. Plug the power supply into an electrical outlet. In essence what you ve just done is zero out the sensor.

Turn the power supply off. The pool cleaner moves but. Ensure the power outlet is functioning properly and that it has not tripped the breaker in the fuse box. Check that the power supply is plugged in and turned on check that the power cable is securely connected all the way into the power supply turn the power supply off.

A known exception the robo kleen power supply puts out about 30 volts a c you read correctly a c. Power supply not rated yet our power supply for our dolphin 3001 will not turn on. You can program the power supply at any time. If no program is selected the robot will perform a single cleaning cycle.

Wait 30 seconds then turn it back on. Pair via bluetooth to your dolphin not a neighbor s. Press the on button the leds will turn on and the robot will start to operate. Take it to your local dealer for further testing or call maytronics customer service.

What about damaged filters. Check the full filter light indicator ensuring that it s off. Going to start a thread to see if anyone has attempted this. Are you happy with what you learned here.

Output voltage should be about 38 volts d c. Unplug the power supply. There may be a problem with the blue cable or the dolphin cleaner itself. Turn the power supply off.

If the outlet is receiving power. It is possible all the brains of direction and what functions to perform are controlled by the power supply box in that case it most likely would not work.